Weight | 0.2 kg |
---|---|
Dimensions | 30 x 20 x 10 cm |
Complements | Aftermarket |
AK Points
Availability: Only 2 left in stock
6,99€
Plastic containers for paint. If you’ve ever done a house renovation, you know it perfectly well.
Container #1 is without a handle. Bucket holders #3, #4 and #5 are marked with the same numbers as the buckets.
Bucket holder #2 should be made of the attached wire. For greater convenience, the holes for mounting the holder in the bucket can be deepened with a 0.3 mm drill bit. However, the bow should be shaped from a section of wire 18.5 mm long on something round with a diameter of 8 mm and should be shaped as shown in the picture.
Painting
Such containers usually are made from white plastic with colourful lids and printed names, logos and labels. The decal is applied as standard — dip the label cut from the sheet of paper for 10 seconds in lukewarm water. After waiting for a moment, the decal can be slid off the backing onto the intended place.
Set Elements
Set contains 8 resin parts to make 5 plastic containers in 1/35 scale.
Recipientes de plástico para pintura. Si alguna vez ha reformado una casa, lo sabe perfectamente.
El contenedor n. ° 1 no tiene asa. Los soportes de cubos # 3, # 4 y # 5 están marcados con los mismos números que los cubos.
El soporte del cubo n. ° 2 debe estar hecho del cable adjunto. Para mayor comodidad, los orificios para montar el soporte en el cubo se pueden profundizar con una broca de 0,3 mm. Sin embargo, el arco debe tener la forma de una sección de alambre de 18,5 mm de largo en algo redondo con un diámetro de 8 mm y debe tener la forma que se muestra en la imagen.
Pintura
Estos recipientes suelen estar hechos de plástico blanco con tapas de colores y nombres, logotipos y etiquetas impresos. La calca se aplica como estándar: sumerja la etiqueta cortada de la hoja de papel durante 10 segundos en agua tibia. Después de esperar un momento, la calca se puede deslizar del respaldo al lugar previsto.
Elementos del set
El juego contiene 8 piezas de resina para hacer 5 envases de plástico a escala 1/35.
Weight | 0.2 kg |
---|---|
Dimensions | 30 x 20 x 10 cm |
Complements | Aftermarket |